Share page: 
PlasmaCAM Basics - Mulvane, KS
PlasmaCAM Basics - Mulvane, KS
Kansas Center for Career and Technical Education
When:  Sat, February 17 2018 08:00 AM - 04:30 PM
Location:  Mulvane High School
Address:  1900 N. Rock Road, Mulvane, KS 67110
Contact:  Tracey Eagon
Contact Phone:  620-235-6006

**REGISTRATION IS OPEN TO THE FIRST 12 PARTICIPANTS**

Workshop Fee = $20.00

WORKSHOP:

This workshop will provide a basic introduction to the PlasmaCAM software and machine setup. Participants will design, program, and cut a small project not exceeding 24" X 24".

This workshop will help the participants work through common problems that students face when working with the PlasmaCAM program.

PRESENTER:

David Dieker has been teaching Production Welding, Residential Electricity, and Heating and Air for the past twelve years at Mulvane High School. He holds a Bachelor's degree in Technology Education from Fort Hays State University. Additionally, David was formally involved with Technology Students Association and started the SkillsUSA chapter at Mulvane High School.

Add To Your Calendar: Export to iCal

Share this event